LATEST FIRMWARES:

Spider Classic Router Firmware 2020: https://setup.spidervpn.org/firmware/0.19/SpiderVPN-classic-2020-10-24_20.13.19-openwrt-19.07.4.bin

Spider Pro Router Firmware 2020: https://setup.spidervpn.org/firmware/0.19/SpiderVPN-pro-2020-10-24_20.13.19-openwrt-19.07.4.bin



1a- Navigate to http://10.11.0.1 on your browser and login using Username: root , Password: admin


1b- Navigate to System -> Flash Latest Firmware -> Browse to choose the attached firmware then click Flash Image and proceed.

**PS: Make sure to untick keep settings option before proceeding

Note: In case you got a message once clicked flash that the image is unsupported which is not a problem and you will just need to check Force Upgrade option and reselect the image again then flash. If you didn't see this Force upgrade button then you will need to download and install firmware version 11/04/19 first.

Note2: If the system asked about firmware authentication details please use the following:
Username: spidersupport
Password: 2es0uGJu2E=#$qW11$

Note: Please note that the installation process should take no longer than 3 minutes. You need to look for Spider 2.4G/5.8G wifi networks and connect to it then complete the setup process.

Once the router finished updating, Please follow the steps below:

1- login to Web Admin Panel at http://10.11.0.1 ,

Username: root
Password: admin

2- Go to Network->Interfaces->WGSPIDER->Edit

3- Select your preferred VPN Location

4- Fill in your Username & Password as follows:

  • VPN Username: **********

Note* find this here> https://spidervpn.org/clientarea/clientarea.php?action=products then Click On Active this is normally your subscription email.

  • VPN Password: **********

Note* Find this here> https://spidervpn.org/clientarea/clientarea.php?action=products then Click On Active.

**Tick the box for Bring Up on Boot and Unblocking DNS if your using for streaming.

5- Click Save then Save & Apply button

6- Wait for 1 minute then your VPN should be connected, Please check the step below to confirm your VPN is connected successfully.

7- Wait for 30 seconds then go Status -> Overview and make sure the Current Public IP Address is not showing your IP Address and is showing the VPN IP Address.

Did this answer your question?